华为交换机将端口由trunk更改成access报错解决方法

    最近想将华为s2300-52p交换机的接口由以前的trunk更改成access时，老是更改不成功，报错信息以下：

[ZGK-BG-Ethernet0/0/6]dis this

#

interface Ethernet0/0/6

 port link-type trunk

 port trunk allow-pass vlan 2 to 4094

 loopback-detect enable

#

return

[ZGK-BG-Ethernet0/0/6]port link-t

[ZGK-BG-Ethernet0/0/6]port link-type access

Error: Please renew the default configurations.

... ...

[ZGK-BG-Ethernet0/0/6]undo port link-type trunk

                                          ^

Error:Too many parameters found at '^' position.

[ZGK-BG-Ethernet0/0/6]undo port link-type

Error: Please renew the default configurations.

[ZGK-BG-Ethernet0/0/6]

    不管如何配置，就是不能将端口有trunk改成access

    后面发现这样配置，就能够将端口更改：

[ZGK-BG-Ethernet0/0/6]dis this

#

interface Ethernet0/0/6

 port link-type trunk

 port trunk allow-pass vlan 2 to 4094

 loopback-detect enable

#

return

[ZGK-BG-Ethernet0/0/6]undo port trunk allow-pass vlan all

Info: This operation may take a few seconds. Please wait for a moment...done.

[ZGK-BG-Ethernet0/0/6]port trunk allow-pass vlan 1

Info: This operation may take a few seconds. Please wait for a moment...done.

[ZGK-BG-Ethernet0/0/6]port link-type access

[ZGK-BG-Ethernet0/0/6]dis this

#

interface Ethernet0/0/6

 port link-type access

 loopback-detect enable

#

return

    成功！

    先去使能全部vlan经过该端口，而后从新添加默认vlan 1经过，以后就能够更改端口类型了！