- 问题1: (error) OOM command not allowed when used memory > 'maxmemory'.
127.0.0.1:8001> info memory # Memory used_memory:2117696 used_memory_human:2.02M
解决办法：redis
调整参数：maxmemory 16mb
- Reason: redis.clients.jedis.exceptions.JedisDataException: DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.. Trying next one. 19:56:51.592 [main] DEBUG redis.clients.jedis.JedisSentinelPool - Connecting to Sentinel 192.168.110.103:26380
解决方法：ide
1) 关闭 protected-mode no 2) 绑定特定IP地址 bind 127.0.0.1 192.168.110.103 3) 设置密码 sentinel auth-pass mymaster 123456
- All sentinels down, cannot determine where is mymaster master is running...
解决方法：oop
配置文件多了 requirepass 123456 这项配置