思科路由器密码恢复

拓扑图：

• 1 配置任意特权加密密码,并保存

Router>enable 
Router#config t 
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#hostname R1
R1(config)#interface g 0/0 
R1(config-if)#ip address 192.168.1.1 255.255.255.0 
R1(config-if)#no shutdown
R1(config-if)#enable secret asdf
%LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up
R1(config)#exit
R1#
%SYS-5-CONFIG_I: Configured from console by console

R1#wr
Building configuration...
[OK]
R1#

• 2 重启路由器reload

• 3 在加载系统过程当中， 使用 Ctrl+Break 键或者 Ctrl+C 键，修改 confreg寄存器的值，使路由器绕过配置文件进入系统

  rommon 1 > help
  boot                boot up an external process
  confreg             configuration register utility
  dir                 list files in file system
  help                monitor builtin command help
  reset               system reset
  set                 display the monitor variables
  tftpdnld            tftp image download
  unset               unset a monitor variable
  rommon 2 > confreg 0x2142
  rommon 3 > reset

• 4 此时已能够不输入密码便可进入系统，这时咱们从新配置密码。配置密码完成后，修改confreg寄存器的值，引导系统正常启动。

Router>en
Router#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#hostname R1
R1(config)#enable sec
R1(config)#enable secret 123abc
R1(config)#config-register 0x2102
R1(config)#end
R1#
%SYS-5-CONFIG_I: Configured from console by console

R1#wr
Building configuration...
[OK]

• 5 最后重启reload