mdm9x07 ATC AT+QCFG usbnet

1     中文AT命令详解

1.1.   AT+QCFG   扩展配置

 

AT+ QCFG    扩展配置
测试命令 AT+QCFG=?	响应 …… +QCFG: "usbnet", (0-3) …… OK
设置命令 AT+QCFG="usbnet",<net>	响应 假如省略参数<net>，返回 +QCFG: "usbnet",<net>   OK   假如不省略，返回 OK ERROR
Maximum Response Time参考	300ms
参考

 

参数

<net>        net端口协议   0  RMNET接口 1      ECM接口 2      MBIM接口 3      RNDIS接口

 

备注

 以上配置将在重启后生效

 

举例

AT+QCFG="usbnet",1                   // 设置USB net口使用ECM标准协议
 OK

 

 

2     Description of AT command

2.1.   AT+QCFG   Extension Configuration

AT+QCFG    Extension Configuration
Test Command  AT+QCFG=?	Response …… +QCFG: "usbnet", (0-3) …… OK
Write Command AT+QCFG="usbnet",<net>	Response If configuration parameters are omitted (+QCFG: "usbnet"), return current configuration:If <net> is absence +QCFG: "usbnet",<net>   OK   If configuration parameters are entered:If not absence OK ERROR
Maximum Response TimeReference	300ms
Reference

 

 

 

 

Parameter:

<net>            The protocol of net port 0  RMNET interface 1  ECM interface 2  MBIM interface 3  RNIDS interface

NMOTES

The Configuration of “usbmodem” and “usbnet” will take effect after reboot.

 

Example

AT+QCFG="usbnet",1                   // Set USB net port to ECM

 

OK