CCNA实验：配置路由器的主机名与ip地址映射表

R3#
R3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R3(config)#hostname Bob

此条配置本路由的名称，除了好记没有什么特殊用途

---

第一步：在Bob上配置主机与IP地址的映射关系
Bob(config)# ip host PEER 1.1.1.2
第二步：查看当前路由器上进行的映射关系配置
R1#sh hosts
Default domain is not set
Name/address lookup uses static mappings

Codes: UN - unknown, EX - expired, OK - OK, ?? - revalidate
temp - temporary, perm - permanent
NA - Not Applicable None - Not defined

Host Port Flags Age Type Address(es)
PEER None (perm, OK) 0 IP 1.1.1.2
第三步：验证
Bob#ping PEER

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 48/69/84 ms